1, Keep the machine clean, especially the cavity, the mold body, piston cover, track surfaces, running tracks and other parts of the bearing surface.
2, The lubrication oil should remain adequate grease filling in strict accordance with requirements, change the oil after 15 days for the first time, oil should be changed every three months thereafter.
3, When hydraulic power is less than 1kg or greater than 3kg gauge, check whether the oil flow is smooth, oil adequacy fittings for leaks, tubing without loss, damage, etc. The body lubrication and oil, should open the cover inspection, if necessary, loose tubing connector, make sure there is enough fuel at each site and then tighten the hose connector. Check the machine body oil strainers and filters, if any obstruction should be promptly removed. Crude oil filter using copper wire mesh.
4, manual greasing requirements of the machine refer to (Figure IV)
5, Always check the electrical system for loose joints, fever, contact burning and so on. Tighten the plate bolts, repair or replace the contact.
6, Take minor repairs every six months from the production date and overhaul once a year.
7, equipment failures and exclusion methods:(to be continued)
Brick block machine
News
